SCONINC變換器SCONI-AH50-14E,出售大秦 DSPT-2B-2DAEYEON轉換器;DY-HSC-BCAA DY-HSC-BCNA
DAEYEON轉換器;DY-HSC-BDAA DY-HSC-BDNA
DAEYEON轉換器;DY-HSC-BOAA DY-HSC-BONA
DAEYEON轉換器;DY-HSC-C1AA DY-HSC-C1NA
DAEYEON轉換器;DY-HSC-C2AA DY-HSC-C2NA
DAEYEON轉換器;DY-HSC-C3AA DY-HSC-C3NA
DAEYEON轉換器;DY-HSC-AA DY-HSC-NA
DAEYEON轉換器;DY-HSC-C5AA DY-HSC-C5NA波形畸變不超過2%。過流整定范圍為2-9.9A(無輔助電源)，級差為0.1A，電流整定值誤差不大于±3%。速動倍數整定范圍為2-9.9倍，級差為0.1倍，電流速動整定值誤差不大于±3%。繼電器的速動電流用電流整定值的倍數表示：速動電流速動倍數×整定電流。速動時間：繼電器任一整定點上，在1.2倍速動電流時的時間不大于50ms。返回系數：不小于0.9。反時限特性曲線方程：t：反時限時間K：延時曲線系數（整定范圍0.1～9.9）。Is：整定電流值I：實際輸入電流值（注：I/Is不大于1.2為不推薦使用段）。反時限特性時間整定誤差：a)當I/Is2時,平均誤差不大于10%；
DAEYEON轉換器;DY-HSC-C6AA DY-HSC-C6NA
DAEYEON轉換器;DY-HSC-CAAA DY-HSC-CANA
DAEYEON轉換器;DY-HSC-CBAA DY-HSC-CBNA
DAEYEON轉換器;DY-HSC-CCAA DY-HSC-CCNA
DAEYEON轉換器;DY-HSC-CDAA DY-HSC-CDNA
DAEYEON轉換器;DY-HSC-COAA DY-HSC-CONA
DAEYEON轉換器;DY-HSC-D1AA DY-HSC-D1NA
DAEYEON轉換器;DY-HSC-D2AA DY-HSC-D2NA

DAEYEON轉換器;DY-HSC-D3AA DY-HSC-D3NA
DAEYEON轉換器;DY-HSC-D4AA DY-HSC-D4NA
DAEYEON轉換器;DY-HSC-D5AA DY-HSC-D5NA
DAEYEON轉換器;DY-HSC-D6AA DY-HSC-D6NA
DAEYEON轉換器;DY-HSC-DAAA DY-HSC-DANA
DAEYEON轉換器;DY-HSC-DBAA DY-HSC-DBNA
DAEYEON轉換器;DY-HSC-DCAA DY-HSC-DCNA
DAEYEON轉換器;DY-HSC-DDAA DY-HSC-DDNA
DAEYEON轉換器;DY-HSC-DOAA DY-HSC-DONA
DAEYEON轉換器;DY-HSC-O1AA DY-HSC-O1NA
DAEYEON轉換器;DY-HSC-O2AA DY-HSC-O2NA

DAEYEON轉換器;DY-HSC-O3AA DY-HSC-O3NA
DAEYEON轉換器;DY-HSC-O4AA DY-HSC-O4NA
DAEYEON轉換器;DY-HSC-O5AA DY-HSC-O5NA
DAEYEON轉換器;DY-HSC-O6AA DY-HSC-O6NA
DAEYEON轉換器;DY-HSC-OAAA DY-HSC-OANA
DAEYEON轉換器;DY-HSC-OBAA DY-HSC-OBNA
DAEYEON轉換器;DY-HSC-OCAA DY-HSC-OCNA
DAEYEON轉換器;DY-HSC-ODAA DY-HSC-ODNA
DAEYEON轉換器;DY-HSC-OOAA DY-HSC-OONA

晶閘管就不能導通。控制極的作用是通過外加正向觸發脈沖使晶閘管導通，卻不能使它關斷。那么，用什么才能使導通的晶閘管關斷呢?使導通的晶閘管關斷，可以斷開陽極電源（圖3中的開關S）或使陽極電流小于維持導通的值（稱為維持電流）。如果晶閘管陽極和陰極之間外加的是交流電壓或脈動直流電壓，那么，在電壓過零時，晶閘管會自行關斷。應用類型圖4示出了雙向可控硅的特性曲線。由圖可見，雙向可控硅的特性曲線是由三兩個象限內的曲線組合成的。象限的曲線說明當加到主電極上的電壓使Tc對T1的極性為正時，我們稱為正向電壓，并用符號U21表示。當這個電壓逐漸到等于轉折電壓UBO時，圖3(b)左邊的可控硅就觸發導通，這時的通態電流為I21。